eVic Basic with CUBIS PRO
|Type:||E - CIGARETTE BRANDS|
|Type:||E - CIGARETTE BRANDS|
The eVic Basic Kit, Wrinkle Finish has the upgradeable firmware with maximum output updating to 60W. It especially comes with the new colorful wrinkle paintings which has a remarkably deep rich texture. The E-juice filling can be easily achieved by simply removing the top cap and injecting into the side holes. The innovative CUBIS Pro Mini with leak resistant cup design allows you to enjoy the best vaping experience ever.
Size: 22.00 x 32.00 x 97.00mm
Battery Capacity: 1500mAh
Output Mode: RTC/VT (Ni/Ti/SS316)/VW/TCR/BYPASS Modes
Output Wattage: 1-60W
e-Juice Capacity: 2ml
Resistance Range: 0.05-1.5ohm for VT/TCR mode
0.1-3.5ohm for VW/BYPASS mode
Temperature Range: 100-315°C/ 200-600°F
Colors: Blue Wrinkle, Red Wrinkle, Orange Wrinkle, Black Wrinkle
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.
New wrinkle finishes: The new wrinkle finish with its deep texture was achieved through a remarkably precise treatment. The end result
is so purely and continuously soft beyond imagination.
Compact size, powerful output (60W)
RTC (Real Time Clock) On Display
Innovative Leak Resistant Cup Design
Exquisite 510 Stainless Steel Thread
Bottom Ventilation Holes
Charging & Upgrading: Simply connect the device with a micro USB cable to charge or upgrade your device. When it's fully charged, the charging indicator will go out.
Power on and off: Press the fire button 5 times in quick succession, the screen will on. Then it's ready to use. In the same way, the device will be turned off by pressing another 5 times in quick succession.
Vaping: Hold the fire button and inhale the mouthpiece. Release the fire button and exhale.
Charging and upgrading: Simply connect the device with a micro USB cable to charge or upgrade. When it's fully charged, the display will go out.
Set screen protection: When the device is on, simultaneously hold the fire button and the right regulatory button to enter into adjustment interface. Press the right button again to enter into screen protection time setting. Choose the protection time and press the fire button to confirm.
Reset: Should you get stuck while upgrade, just press the "+" button and then insert into the reset hole with a needle to restart.
Switch among different modes: Press the fire button 3 times to enter into the setting menu. Press the right regulatory button to switch among TEMP, TCR, Power and BYPASS modes. Press the fire button to confirm. And press left button while flashing to enter into subsidiary menu.
How to set the TCR: In power-off condition, press the fire button and right regulator simultaneously for about 5 seconds to enter into TCR set menu:
1. Press right/left regulator to choose between TCR M1, M2, M3;
2. Then press the fire button to select certain parameter;
3. Press the regulator to set the parameter;
4. Long press the fire button or leave it for about 10 seconds to confirm.