JOYETECH eGo One & v2 coil Heads (ego one coil 1.0 ohm)
Note: Before buying customer Should Select Type of coils Head For Joyetech Model E-cigarettes
1)The Joyetech eGo ONE coil/Atomizer Heads are introduced with unique design and functionally working with- Joyetech eGo ONE , ego one V2 series ,coil resistance: 1.0ohm, 0.5ohm
2) Joyetech eGo One CLR coil/Atomizer Heads is the specially designed atomizer head for Joyetech eGo One. With CLR head, you’re able to rebuild it while performance diminishing. Get it to enjoy vape and DIY fun!
CLR Pre-made coil resistance: 1.0ohm, 0.5ohm
CLR coil Operation Steps
1.Prepare the heating wire. Standard heating wire for example. Take a piece of heating wire of around 60millimeters long and roll the heating wire; Reserve around 8.5mm on one side, and then rotate 5 - 6 circles reserving around 7mm on the other side. Bend a little at bot ends.
2.Install the regulating ring to the atomizer tube and screw it tightly. This ring could adjust the amount of liquid entering.
3.Put the heating wire into the tube, and keep it in the center position.
4.Put the long end into notch, pass the short end through the insulating ring.
5.Install the insulating ring and connection base to the tube.
6.Adjust the position of the heating wire and make the cotton cross the heating coil, cut off the redundant cotton to keep flush with liquid entering notches.
7.Screw on the top cap tightly.
Remark: please drip a few drops of e-juice on the cotton and make sure it is moist before the first use, or it will burn.
Packing Details :
1 x PCS ( any tpye of Coil/ automizer)